Cable Accessories for Stepper Motor Controller SMC75 and other Motion Control Products
The following equipment is recommended for use with the Stepper Motor Controller SMC75:
| Partnumber | Description | Connector type | |
| WG0801 | Cable 65mm for SMC75 PCB 8 IO M12 8pin Fem with white 10pin JST connector |  |
|
| WG0802 | Cable 65mm for SMC75 PCB CAN bus M12 M5 with white 6pin JST connector |  |
|
| WG0803 | Cable 65mm for SMC75 PCB Power. M12 5pin Male with 3 pin Molex connect |  |
|
| WG0804 | Cable 65mm for SMC75 PCB RS485. 2pcs M12 used in M3 version |  |
|
| WG0805 | Cable 65mm for MIS motor puls/dir 8pin-M12 male |  |
|
| WG0807 | Cable 65mm for MIS SSI encoder interface + 2IO M12 8pin male |  |
|
| WG0811 | Cable 65mm for CANBUS M12 Male and M12 Fem |  |
|
| WG0795 | Cable 0,5m for SMC75 PCB 10p without M12, 10wire free end |  |
|
| WG0901 | Power cable 1m 3x0.75+shield Ø6mm Also available in 2, 5 and 10m |  |
|
| WG1001 | QS IO cable 1m 16xAWG28+shield Ø6mm. Also available in 2, 5 and 10m |  |
|
| HEAD4LS | Header 4 pin for motor connection |  |
|
| WG0104 | 4 pol con. 4 wire. 1m. 0,5' for HEAD4LS motor connection |  |
|
| SPOD-36-B-069-1 | J1 counterpart Male header 11.4mm B/B |
||
| SPOD-36-B-125-1-R | J1 counterpart Male header 16.5mm B/B |
||
| SPOD-36-B-212-1 | J1 counterpart Male header 25.5mm B/B |
JVL A/S Bregnerødvej 127 DK-3460 Birkerød Denmark
Tel: +45 4582 4440 Fax: +45 4582 5550 E-mail: jvl@jvl.dk
Tel: +45 4582 4440 Fax: +45 4582 5550 E-mail: jvl@jvl.dk
